Advanced Keys AK-104 User Manual download pdf (Page 7)

PUSH-START IGNITION (OPTIONAL)

If installed, the Push-Start Ignition system will be enabled when a

valid Smart Key is detected. The “ENGINE START STOP” button

backlight will be illuminated and Status LED showing a solid

amber light indicating vehicle is ready for ignition.

Following shows the operations of the Push-Start system:

Switching Ignition States

When system is in Readymode (Status LED is Amber) and

without apply brake:

 Press button 1st time: ACC (Status LED: Green)

 Press button 2nd time: ON (Status LED: Flashing Green)

 Press button 3rd time: Ready (Status LED: Amber)

To Start the Engine

Apply brake and when the Status LED starts to flash Red:

 Tach: Tap button once to start engine automatically.

 Tachless: Press and hold the button until engine started.

Note: You may start the engine from any ignition state.

Emergency Ignition: (Without Brake) Press and hold Start

Button for 1.5 seconds to start the engine.

To Stop the Engine

Make sure the vehicle is stopped and in Parked (P) position

Apply brake and press and hold the button for 0.5 seconds

until the engine stops.

Emergency Stop: (Without Brake) Press and hold Start

Button for 3 seconds to stop the engine.

Status LED

Backlight

Status LED Backlight Description

OFF OFF Push-Start Ignition Disabled / Engine Starting

Amber ON Push-Start Ignition Enabled

Red (flashing) ON Ready to Start Engine

Green ON Accessory (ACC) State

Green (flashing) ON Ignition (ON) State

OFF ON Ignition (RUN) State

Green – Red (flashing) ON System Initializing / Tach Programming Mode

PUSH-START (BUTTON) LED DESCRIPTION

• DO NOT PRESS THE PUSH-START BUTTON WHILE VEHICLE IS IN MOTION.

• To stop ignition in an emergency situation always change gear to Neutral first

then press and hold the Push-Start button for 3 seconds.

• When exposed to direct sunlight the Push-Start button maybe hot to touch.

WARNING

1 2 3 4 5 6 7

No comments

Advanced Keys AK-104 User Manual Page 7